INSTALLATION
CAUTION / NOTICE / HINT
HINT:
PROCEDURE
1. INSTALL FRONT DOOR COURTESY LIGHT SWITCH ASSEMBLY
(a) Using a T30 "TORX" socket wrench, install the front door courtesy light switch assembly with the screw.
|
Install in this Direction |
Torque:
6.0 N·m {61 kgf·cm, 53 in·lbf}
(b) Connect the connector.
2. INSTALL CENTER PILLAR LOWER GARNISH
Click here
3. CONNECT REAR DOOR OPENING TRIM WEATHERSTRIP
|
(a) Connect the rear door opening trim weatherstrip to the area shown in the illustration. |
|
4. CONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP
|
(a) Connect the front door opening trim weatherstrip to the area shown in the illustration. |
|
5. CONNECT FRONT SEAT OUTER BELT ASSEMBLY
Click here
6. INSTALL LAP BELT OUTER ANCHOR COVER
Click here
7. INSTALL REAR DOOR SCUFF PLATE (w/ Rear Seat Side Airbag)
Click here
8. INSTALL REAR DOOR SCUFF PLATE (w/o Rear Seat Side Airbag)
Click here
9. INSTALL FRONT DOOR SCUFF PLATE
Click here
10. INSTALL REAR SEAT CUSHION LOCK HOOK
Click here
11. INSTALL BENCH TYPE REAR SEAT CUSHION ASSEMBLY
Click here
Inspection
Glove Box LightToyota CH-R Service Manual > Tire Pressure Warning System: Transmitter ID not Received in Main Mode (C2126/26)
DESCRIPTION
After all IDs are registered, DTC C2126/26 is stored in the tire pressure warning
ECU and receiver and the tire pressure warning light blinks for 1 minute and then
illuminates.
When the tire pressure warning ECU and receiver successfully receives radio waves
from all the transmit ...
Toyota CH-R Owners Manual > Engine compartment: Washer fluid
Add washer fluid in the following situations:
A washer does not work.
The warning message appears on the multi-information display (if equipped).
The washer fluid level is extremely low (type A) or at "LOW" (type B).
Type A
Raise the cap keeping your finger pressed down ...