Toyota CH-R Service Manual: Inspection

INSPECTION

PROCEDURE

1. INSPECT FRONT DOOR COURTESY LIGHT SWITCH ASSEMBLY

(a) Check the resistance.

(1) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

1 - Switch body

Not pushed (ON)

Below 1 Ω

Pushed (OFF)

10 kΩ or higher

If the result is not as specified, replace the front door courtesy light switch assembly.

*a

Component without harness connected

(Front Door Courtesy Light Switch Assembly)

*b

Switch Body

    Removal
    REMOVAL CAUTION / NOTICE / HINT HINT: Use the same procedure for the LH and RH sides. The procedure described below is for the LH side. PROCEDURE 1. REMOVE BENCH TYPE REAR SEAT ...

    Installation
    INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for the LH and RH sides. The procedure described below is for the LH side. PROCEDURE 1. INSTALL FRONT DOOR COUR ...

    Other materials:

    Toyota CH-R Service Manual > Steering Pad: On-vehicle Inspection
    ON-VEHICLE INSPECTION CAUTION / NOTICE / HINT CAUTION: Be sure to correctly follow the removal and installation procedures for the horn button assembly. PROCEDURE 1. INSPECT HORN BUTTON ASSEMBLY (for Vehicle not Involved in Collision) (a) Perform a diagnostic system check. Click here (b) ...

    Toyota CH-R Service Manual > Audio And Visual System(for Radio And Display Type): Sending Malfunction (Navigation to APGS) (U0073,U0100,U0129,U0140,U0155,U0164)
    DESCRIPTION These DTCs are stored when a malfunction occurs in the CAN communication circuit. DTC No. Detection Item DTC Detection Condition Trouble Area U0073 Sending Malfunction (Navigation to APGS) CAN bus connec ...

    Toyota C-HR (AX20) 2023-2026 Owner's Manual

    Toyota CH-R Owners Manual

    Toyota CH-R Service Manual

    © 2017-2026 Copyright www.tochr.net
    0.0072