REMOVAL
CAUTION / NOTICE / HINT
HINT:
PROCEDURE
1. REMOVE BENCH TYPE REAR SEAT CUSHION ASSEMBLY
Click here
2. REMOVE REAR SEAT CUSHION LOCK HOOK
Click here
3. REMOVE FRONT DOOR SCUFF PLATE
Click here
4. REMOVE REAR DOOR SCUFF PLATE (w/ Rear Seat Side Airbag)
Click here
5. REMOVE REAR DOOR SCUFF PLATE (w/o Rear Seat Side Airbag)
Click here
6. REMOVE LAP BELT OUTER ANCHOR COVER
Click here
7. DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY
Click here
8. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP
(a) Disconnect the front door opening trim weatherstrip from the area shown in the illustration. |
|
9. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP
(a) Disconnect the rear door opening trim weatherstrip from the area shown in the illustration. |
|
10. REMOVE CENTER PILLAR LOWER GARNISH
Click here
11. REMOVE FRONT DOOR COURTESY LIGHT SWITCH ASSEMBLY
(a) Disconnect the connector.
(b) Using a T30 "TORX" socket wrench, remove the screw and front door courtesy light switch assembly.
![]() |
Remove in this Direction |
Toyota CH-R Service Manual > Vehicle Stability Control System: Open in ABS Solenoid Relay Circuit (C146E)
DESCRIPTION
The ABS solenoid relay is built into the skid control ECU in the brake actuator
assembly. The ABS solenoid relay supplies power to the ABS and TRAC solenoids. The
skid control ECU detects a solenoid relay malfunction by performing a self check
and relay operation check.
...
Toyota CH-R Service Manual > Blower Unit(for Valeo Made): Disassembly
DISASSEMBLY
PROCEDURE
1. PRECAUTION
NOTICE:
Make sure to perform initialization after replacing the No. 1 blower damper servo
sub-assembly. If initialization is not performed, the air conditioner unit assembly
will not perform properly as the air conditioning amplifier assembly will not be
...