DTC CHECK / CLEAR
CHECK DTC
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Navigation System / Trouble Codes.
Body Electrical > Navigation System > Trouble Codes(e) Check for DTCs.
NOTICE:
The radio and display receiver assembly outputs DTCs for the following system. When DTCs other than those in Diagnostic Trouble Code Chart for the rear view monitor system are output, refer to Diagnostic Trouble Code Chart for the relevant systems.
|
System |
Proceed to |
|---|---|
|
Audio and Visual System*1 |
|
|
Navigation System*2 |
|
CLEAR DTC
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Navigation System / Trouble Codes.
Body Electrical > Navigation System > Clear DTCs(e) Clear the DTCs.
Diagnosis System
Diagnostic Trouble Code ChartToyota CH-R Service Manual > Personal Light: Installation
INSTALLATION
PROCEDURE
1. INSTALL MAP LIGHT ASSEMBLY
(a) Connect each connector.
(b) Engage the guide and clips to install the map light assembly as shown in
the illustration.
Install in this Direction (1)
Install in this Direction (2)
...
Toyota CH-R Service Manual > Vehicle Stability Control System: Steering Angle Sensor Power Source Voltage Malfunction (C1432)
DESCRIPTION
This DTC is stored when the skid control ECU (brake actuator assembly) receives
a +B line open signal from the steering angle sensor.
DTC No.
Detection Item
DTC Detection Condition
Trouble Area
C1432
Steering Ang ...