REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the oil pressure sensor removal/installation are shown below.
Necessary Procedure After Parts Removed/Installed/Replaced|
Replacement Part or Procedure |
Necessary Procedure |
Effect/Inoperative when not Performed |
Link |
|---|---|---|---|
|
Replacement of oil pressure sensor |
Perform the following procedures in the order shown:
|
Deterioration of fuel efficiency |
|
PROCEDURE
1. REMOVE FRONT WHEEL LH
Click here
2. REMOVE NO. 1 ENGINE UNDER COVER
Click here
3. REMOVE REAR ENGINE UNDER COVER LH
Click here
4. REMOVE OIL PRESSURE SENSOR
(a) Disconnect the oil pressure sensor connector.
|
(b) Using SST, remove the oil pressure sensor from the continuously variable transaxle assembly. SST: 09326-22011 |
|
Components
InstallationToyota CH-R Service Manual > Front Differential Oil Seal: Components
COMPONENTS
ILLUSTRATION
*1
NO. 1 ENGINE UNDER COVER
*2
REAR ENGINE UNDER COVER LH
*3
REAR ENGINE UNDER COVER RH
-
-
N*m (kgf*cm, ft.*lbf): Specified torque
-
...
Toyota CH-R Service Manual > Instrument Panel Safety Pad: Reassembly
REASSEMBLY
PROCEDURE
1. INSTALL NO. 1 INSTRUMENT PANEL CUSHION
(a) Install a new instrument panel cushion as shown in the illustration.
Standard Measurement:
Area
Measurement
A
3.0 mm (0.118 in.)
...