UNDER HOOD
GENERAL NOTES
WINDSHIELD WASHER FLUID
(a) Check that there is sufficient fluid in the tank.
ENGINE COOLANT LEVEL
(a) Check that the coolant level is between the "FULL" and "LOW" lines on the see-through reservoir.
RADIATOR AND HOSES
(a) Check that the front of the radiator is clean and not blocked by leaves, dirt and bugs.
(b) Check the radiator and hoses for:
BATTERY ELECTROLYTE LEVEL
(a) Check that the electrolyte level of all the battery cells is between the upper and lower level lines on the case.
HINT:
If the electrolyte level is difficult to see, lightly shake the vehicle.
BRAKE FLUID LEVEL
(a) Check that the brake fluid level is near the upper level line on the see-through reservoir.
ENGINE DRIVE BELT
(a) Check the drive belt for fraying, cracks, wear or oil.
ENGINE OIL LEVEL
(a) Check that the engine oil level is between the full level and low level marks on the dipstick with the engine turned off.
CONTINUOUSLY VARIABLE TRANSAXLE FLUID
(a) Visually check the overflow plug and oil pan for fluid leaks or traces of fluid.
EXHAUST SYSTEM
(a) Visually inspect for severe corrosion, cracks, holes or loose supports.
HINT:
If any change in the sound of the exhaust or smell of the exhaust fumes is noticed, inspect and repair the exhaust system.
Inside Vehicle
EngineToyota CH-R Service Manual > Blind Spot Monitor System: Slave Module Horizontal Axis Misalignment (C1AC2)
DESCRIPTION
This DTC is stored when the angle of the blind spot monitor sensor RH (Slave)
deviates more than the allowable range from the horizontal axis.
HINT:
If a drum tester such as a speedometer tester, brake/speedometer combination
tester or chassis dynamometer is used with th ...
Toyota CH-R Service Manual > Headlight Dimmer Switch: Removal
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration)
that must be performed after parts are removed and installed, or replaced during
the headlight dimmer switch assembly removal/ installation are shown below.
Necessary Procedure A ...