ENGINE
HINT:
Perform these procedures after the engine has cooled down.
INSPECT DRIVE BELT
(a) Check the drive belt.
Click here
INSPECT ENGINE OIL AND OIL FILTER
(a) Check the engine oil and oil filter.
Click here
INSPECT ENGINE COOLANT
(a) Check the engine coolant.
Click here
INSPECT SPARK PLUGS
(a) Check the spark plugs.
Click here
INSPECT BATTERY
(a) Check the battery.
Click here
INSPECT AIR CLEANER FILTER ELEMENT
(a) Remove the air cleaner filter element.
(b) Check that the air cleaner filter element is not excessively dirty.
If the air cleaner filter element is excessively dirty, replace the air cleaner filter element.
(c) If cleaning the air cleaner filter element, blow compressed air as shown in the illustration to clean it.
(d) Reinstall the air cleaner filter element.
INSPECT EXHAUST PIPES AND MOUNTINGS
(a) Visually check the pipes, hangers and connections for severe corrosion, leaks or damage.
INSPECT FUEL TANK CAP GASKET
(a) Check the fuel tank cap gasket.
Click here
Click here
INSPECT FUEL LINES, CONNECTIONS, FUEL TANK VAPOR VENT SYSTEM HOSES AND FUEL TANK BANDS
(a) Visually check the fuel lines and hoses for cracks, leaks, loose connections, or deformation.
(b) Check for tank band looseness or deformation.
INSPECT CHARCOAL CANISTER
(a) Check the charcoal canister.
Click here
Click here
Under Hood
BrakeToyota CH-R Service Manual > Power Window Control System: All Power Windows do not Operate with Driver Side Door Key Cylinder or Wireless
Transmitter
DESCRIPTION
Wireless Transmitter-linked Function
w/ Smart Key System:
When an electronic key transmitter sub-assembly switch is pushed:
1) the door control receiver receives the wireless door lock signal;
2) the door control receiver sends a signal to the main bod ...
Toyota CH-R Service Manual > Immobiliser System(w/o Smart Key System): Terminals Of Ecu
TERMINALS OF ECU
CHECK TRANSPONDER KEY ECU ASSEMBLY
(a) Disconnect the F22 transponder key ECU assembly connector.
(b) Measure the resistance and voltage according to the value(s) in the table
below.
HINT:
Measure the values on the wire harness side with the connector disconnected.
...