BRAKE
INSPECT BRAKE LINE PIPES AND HOSES
HINT:
Work in a well-lighted area. Turn the front wheels fully to the right or left before beginning the inspection.
(a) Using a mirror, check the entire circumference and length of the brake lines and hoses for:
(b) Check all the clamps for tightness and check the connections for leakage.
(c) Check that the hoses and lines are not near sharp edges, moving parts or the exhaust system.
(d) Check that the lines are installed properly and pass through the center of the grommets.
INSPECT BRAKE PEDAL
(a) Check the brake pedal.
Click here
INSPECT PARKING BRAKE
(a) Check the parking brake.
INSPECT FRONT BRAKE
(a) Check the front brake pads and discs.
Click here
INSPECT REAR BRAKE
(a) Check the rear brake pads and discs.
Click here
Click here
INSPECT OR CHANGE BRAKE FLUID
(a) Inspect or change the brake fluid.
Click here
Fluid:
SAE J1703 or FMVSS No. 116 DOT3
SAE J1704 or FMVSS No. 116 DOT4
Engine
ChassisToyota CH-R Service Manual > Audio And Visual System(for Radio And Display Type): Operation Check
OPERATION CHECK
STORAGE CHECK (DCU STORAGE CHECK)
NOTICE:
When replacing the radio and display receiver assembly, always replace it with
a new one. If a radio and display receiver assembly which was installed to another
vehicle is used, the following may occur:
A communication malfunc ...
Toyota CH-R Service Manual > Air Conditioning Unit(for Denso Made): Reassembly
REASSEMBLY
PROCEDURE
1. INSTALL NO. 1 COOLER THERMISTOR
Click here
2. INSTALL NO. 1 COOLER EVAPORATOR SUB-ASSEMBLY
(a) Install the No. 1 cooler evaporator sub-assembly with the No. 1 cooler
thermistor to the upper heater case.
...