Pressing the switch changes the vehicle-to-vehicle distance as follows:
The vehicle-to-vehicle distance is set automatically to long mode when the engine switch is turned to the "ON" position (vehicles without a smart key system) or IGNITION ON mode (vehicles with a smart key system).
If a vehicle is running ahead of you, the preceding vehicle mark will also be displayed.

Vehicle-to-vehicle distance settings (vehicle-to-vehicle distance control mode)
Select a distance from the table below. Note that the distances shown correspond to a vehicle speed of 50 mph (80 km/h). Vehicle-to-vehicle distance increases/decreases in accordance with vehicle speed.
When the vehicle is stopped by system control, the vehicle stops at a certain vehicle-to-vehicle distance depending on the situation.
| Distance options | Vehicle-to-vehicle distance |
| Long | Approximately 160 ft. (50 m) |
| Medium | Approximately 130 ft. (40 m) |
| Short | Approximately 100 ft. (30 m) |
Resuming follow-up cruising when the vehicle has been stopped by system control (vehicle-to-vehicle distance control mode)
After the vehicle ahead of you starts off, push the lever up.
Your vehicle will also resume follow-up cruising if the accelerator pedal is depressed after the vehicle ahead of you starts off.

Adjusting the set speed
Canceling and resuming the speed controlToyota CH-R Owners Manual > Operating the lights and wipers: Windshield wipers and washer
Operating the wiper lever
Operate
lever as follows to select the wiper operation.
Intermittent windshield wipers with interval adjuster
When intermittent windshield wiper operation is selected, the wiper interval
can be also adjusted.
OFF *1 or
*2
Off
INT *1 or
*2
Intermittent w ...
Toyota CH-R Service Manual > Front Brake: Inspection
INSPECTION
PROCEDURE
1. INSPECT BRAKE CYLINDER AND PISTON
(a) Check the front disc brake cylinder bore and front disc brake piston for
rust and scoring. If necessary, replace the front disc brake cylinder assembly and
front disc brake piston.
2. INSPECT PAD LINING THICKNESS
(a) U ...