Toyota CH-R Service Manual: How To Proceed With Troubleshooting

Toyota CH-R Service Manual / Lighting (ext) / Lighting System / How To Proceed With Troubleshooting

CAUTION / NOTICE / HINT

HINT:

Use the following procedure to troubleshoot the lighting system.

*: Use the Techstream.

PROCEDURE

1.	VEHICLE BROUGHT TO WORKSHOP

2.	CUSTOMER PROBLEM ANALYSIS AND SYMPTOM CHECK

3.	INSPECT BATTERY VOLTAGE

(a) Measure the battery voltage.

Standard Voltage:

11 to 14 V

If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.

4.	INSPECT CAN COMMUNICATION SYSTEM*

(a) Use the Techstream to check if the CAN communication system is functioning normally.

Click here

Result	Proceed to
CAN communication system DTCs are not output	A
CAN communication system DTCs are output	B

GO TO CAN COMMUNICATION SYSTEM

5.	CHECK FOR DTC*

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch to ON.

(d) Enter the following menus: Body Electrical / Main body / Trouble Codes.

(e) Check for DTCs.

Click here

Body Electrical > Main Body > Trouble Codes Body Electrical > HL AutoLeveling > Trouble Codes

Result	Proceed to
DTCs are not output	A
DTCs are output	B

GO TO DIAGNOSTIC TROUBLE CODE CHART (LIGHTING SYSTEM)

6.	PROBLEM SYMPTOMS TABLE

(a) Refer to Problem Symptoms Table.

Click here

Result	Proceed to
Fault is not listed in Problem Symptoms Table	A
Fault is listed in Problem Symptoms Table	B

GO TO PROBLEM SYMPTOMS TABLE

7.	OVERALL ANALYSIS AND TROUBLESHOOTING*

(a) Data List / Active Test

Click here

(b) Terminals of ECU

Click here

(d) On-vehicle Inspection

8.	ADJUST, REPAIR OR REPLACE

9.	CONFIRMATION TEST

END

System Diagram

SYSTEM DIAGRAM HEADLIGHT ASSEMBLY (for LED Headlight) ...

SYSTEM DESCRIPTION AUTOMATIC LIGHT CONTROL SYSTEM (a) When the light control switch is in the AUTO position, the automatic light control system detects ambient light levels and controls the low be ...

Other materials:

Toyota CH-R Service Manual > Tire Pressure Warning System: Initialization
INITIALIZATION NOTICE: Initialization can be confirmed through the tire pressure warning light. If the ignition switch off during initialization, the tire pressure warning ECU and receiver memorizes that initialization was being performed. Therefore, it is not necessary to p ...

Toyota CH-R Service Manual > Automatic High Beam System: Data List / Active Test
DATA LIST / ACTIVE TEST DATA LIST NOTICE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not. HINT: Using the Techstream to read the Data List allows the ...

Toyota CH-R Service Manual: How To Proceed With Troubleshooting

System Diagram

System Description

Other materials:

Toyota C-HR (AX20) 2023-2025 Owner's Manual

Toyota CH-R Owners Manual

Toyota CH-R Service Manual