Toyota CH-R Service Manual: Inspection

INSPECTION

PROCEDURE

1. INSPECT BRAKE VACUUM CHECK VALVE ASSEMBLY

(a) Check that there is ventilation from the booster to the engine, and no ventilation from the engine to the booster.

If the results are not as specified, replace the brake vacuum check valve assembly.

*a

Ventilation

*b

No Ventilation

    Disassembly
    DISASSEMBLY PROCEDURE 1. REMOVE BRAKE VACUUM CHECK VALVE ASSEMBLY (a) Remove the brake vacuum check valve assembly from the brake booster assembly. (b) Remove the check valve grommet from the brak ...

    Reassembly
    REASSEMBLY PROCEDURE 1. INSTALL VACUUM WARNING SWITCH ASSEMBLY (a) Install a new check valve grommet to the brake booster assembly. (b) Install the vacuum sensor assembly to the brake b ...

    Other materials:

    Toyota CH-R Service Manual > Blower Unit(for Valeo Made): Removal
    REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the blower unit removal/installation are shown below. Necessary Procedure After Parts Removed/Insta ...

    Toyota CH-R Service Manual > Vacuum Pump: Disassembly
    DISASSEMBLY PROCEDURE 1. REMOVE END COVER (a) Using a T25 "TORX" socket wrench, remove the 5 screws and end cover. NOTICE: Hold the vacuum pump assembly so that its installation surface, fitting parts and oil pipe will not be damaged. As the vac ...

    Toyota C-HR (AX20) 2023-2026 Owner's Manual

    Toyota CH-R Owners Manual

    Toyota CH-R Service Manual

    © 2017-2026 Copyright www.tochr.net
    0.008