Toyota CH-R Service Manual: How To Proceed With Troubleshooting

CAUTION / NOTICE / HINT

HINT:

  • Use the following procedure to troubleshoot the meter / gauge system.
  • *: Use the Techstream.

PROCEDURE

1.

VEHICLE BROUGHT TO WORKSHOP

NEXT

2.

CUSTOMER PROBLEM ANALYSIS

NEXT

3.

INSPECT BATTERY VOLTAGE

(a) Measure the battery voltage.

Standard voltage:

11 to 14 V

If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.

NEXT

4.

CHECK CAN COMMUNICATION SYSTEM*

(a) Check if CAN communication DTCs are output.

Click here

Result

Proceed to

CAN communication DTCs are not output.

A

CAN communication DTCs are output.

B

B

GO TO CAN COMMUNICATION SYSTEM

A

5.

CHECK FOR DTC*

(a) Check for DTCs.

Click here

Body Electrical > Combination Meter > Trouble Codes

Result

Proceed to

DTCs are not output.

A

DTCs are output.

B

B

GO TO DIAGNOSTIC TROUBLE CODE CHART

A

6.

PROBLEM SYMPTOM CONFIRMATION

NEXT

7.

SYMPTOM SIMULATION

NEXT

8.

PROBLEM SYMPTOMS TABLE

(a) Refer to Problem Symptoms Table.

Click here

Result

Proceed to

Fault is not listed in Problem Symptoms Table.

A

Fault is listed in Problem Symptoms Table.

B

B

GO TO PROBLEM SYMPTOMS TABLE

A

9.

CIRCUIT INSPECTION

NEXT

10.

REPAIR OR REPLACE

NEXT

11.

CONFIRMATION TEST

NEXT

END

    Customize Parameters
    CUSTOMIZE PARAMETERS CUSTOMIZE METER / GAUGE SYSTEM (a) Customizing with the Techstream. (1) Connect the Techstream to the DLC3. (2) Turn the ignition switch ON. (3) Turn the Techstream on. (4) ...

    Initialization
    INITIALIZATION MAINTENANCE REQUIRED REMINDER RESET PROCEDURE (a) Turn the ignition switch ON. (b) Using the steering pad switch assembly, display the setting display on the multi-information disp ...

    Other materials:

    Toyota CH-R Service Manual > Rear Suspension Member: Components
    COMPONENTS ILLUSTRATION *1 TAIL EXHAUST PIPE ASSEMBLY *2 COMPRESSION SPRING N*m (kgf*cm, ft.*lbf): Specified torque - - ILLUSTRATION *1 REAR FLEXIBLE HOSE LH ...

    Toyota CH-R Service Manual > Washer Motor: Inspection
    INSPECTION PROCEDURE 1. INSPECT WINDSHIELD WASHER MOTOR AND PUMP ASSEMBLY (for Front Side) HINT: This check should be performed with the windshield washer motor and pump assembly installed to the windshield washer jar assembly. (a) Fill the windshield washer jar assembly with washer fluid. ...

    Toyota C-HR (AX20) 2023-2026 Owner's Manual

    Toyota CH-R Owners Manual

    Toyota CH-R Service Manual

    © 2017-2026 Copyright www.tochr.net
    0.0067