Toyota CH-R Service Manual: Initialization

INITIALIZATION

MAINTENANCE REQUIRED REMINDER RESET PROCEDURE

(a) Turn the ignition switch ON.

(b) Using the steering pad switch assembly, display the setting display on the multi-information display.

(c) Select "Maintenance System" from the setting display and perform initialization according to the multi-information display.

HINT:

After initialization is complete, "Initialization Completed" will be displayed on the multi-information display.

    How To Proceed With Troubleshooting
    CAUTION / NOTICE / HINT HINT: Use the following procedure to troubleshoot the meter / gauge system. *: Use the Techstream. PROCEDURE 1. VEHICL ...

    Problem Symptoms Table
    PROBLEM SYMPTOMS TABLE NOTICE: When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, th ...

    Other materials:

    Toyota CH-R Service Manual > Vehicle Stability Control System: Brake Warning Light does not Come ON
    DESCRIPTION The skid control ECU (brake actuator assembly) is connected to the combination meter assembly via CAN communication. CAUTION / NOTICE / HINT NOTICE: When replacing the skid control ECU (brake actuator assembly), perform system variant learning. Click here ...

    Toyota CH-R Service Manual > Front Door Outside Moulding: Disassembly
    DISASSEMBLY CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH and LH sides. The procedure listed below is for the LH side. PROCEDURE 1. REMOVE FRONT DOOR UPPER OUTSIDE MOULDING PAD (a) Remove the front door upper outside moulding pad. ...

    © 2017-2021 Copyright www.tochr.net
    0.0152