PROBLEM SYMPTOMS TABLE
NOTICE:
When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.
HINT:
Click here
|
Symptom |
Suspected Area |
Link |
|---|---|---|
|
Entire combination meter assembly does not operate |
Power source circuit |
|
|
Speedometer malfunction |
Speedometer circuit |
|
|
Tachometer malfunction |
Tachometer circuit |
|
|
Fuel receiver gauge malfunction |
Fuel receiver gauge circuit |
|
|
Engine coolant temperature receiver gauge malfunction |
Engine coolant temperature receiver gauge circuit |
|
|
Symptom |
Suspected Area |
Link |
|---|---|---|
|
Engine oil pressure warning light malfunction |
Engine oil pressure switch circuit |
|
|
Other indicator lights malfunction |
Combination meter assembly |
|
|
Other warning lights malfunction |
Combination meter assembly |
|
|
Symptom |
Suspected Area |
Link |
|---|---|---|
|
Multi-information display is not displayed |
Combination meter assembly |
|
|
Engine Oil Pressure Low display malfunction |
Engine oil pressure switch circuit |
|
|
Low washer fluid display malfunction*1 |
Washer fluid level warning switch circuit |
|
|
Other display malfunction |
Combination meter assembly |
|
|
Symptom |
Suspected Area |
Link |
|---|---|---|
|
Oil pressure warning buzzer malfunction |
Engine oil pressure switch circuit |
|
|
Other buzzers malfunction |
Combination meter assembly |
|
|
Symptom |
Suspected Area |
Link |
|---|---|---|
|
Entire combination meter does not operate |
Power source circuit |
|
|
Operating steering pad switch does not change main display |
Steering pad switch circuit |
|
|
Operating steering pad switch does not change multi-information display |
Steering pad switch circuit |
|
|
Meter illumination is always dark |
Illumination circuit (Meter illumination is always dark) |
|
|
Meter illumination does not dim at night |
Illumination circuit (Meter illumination does not dim at night) |
|
|
Meter illumination does not dim when the taillights are turned on |
Combination meter assembly |
|
|
Other systems that use the speed signal do not operate normally |
Speed signal circuit |
|
Initialization
Terminals Of EcuToyota CH-R Owners Manual > Essential information: Emergency flashers
The emergency flashers are used to warn other drivers when the vehicle
has to be stopped in the road due to a breakdown, etc.
Press the switch.
All the turn signal lights will flash.
To turn them off, press the switch once again.
■Emergency flashers If the emergency flashers are used for ...
Toyota CH-R Service Manual > Vehicle Stability Control System: Yaw Rate Sensor Malfunction (C1436)
DESCRIPTION
This DTC is stored when the skid control ECU (brake actuator assembly) detects
improper installation of the yaw rate and acceleration sensor (airbag sensor assembly)
or an abnormality in the difference between the yaw rate sensor value and the control
value estimated based on the ...