Toyota CH-R Service Manual: Engine Control System Malfunction (C1201)

Toyota CH-R Service Manual / Brake Control / Dynamic Control Systems / Vehicle Stability Control System / Engine Control System Malfunction (C1201)

DESCRIPTION

If a malfunction in the SFI system is detected, the operation of VSC and TRAC is prohibited by the fail-safe function. When the signals from the engine are received normally, fail-safe control is canceled.

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

C1201

Engine Control System Malfunction

Engine control system malfunction signal continues for 2.5 seconds.

SFI system

PROCEDURE

1.

CHECK SFI SYSTEM

(a) Check if SFI system DTCs are output.

w/o Canister Pump Module: Click here

w/ Canister Pump Module: Click here

Result

Proceed to

DTCs are not output.

A

DTCs are output.(w/o Canister Pump Module)

B

DTCs are output.(w/ Canister Pump Module)

C

HINT:

If troubleshooting has been carried out according to Problem Symptoms Table, refer back to the table and proceed to the next step before replacing parts.

Click here

A

REPLACE ECM

B

INSPECT SFI SYSTEM

C

INSPECT SFI SYSTEM

    ABS Warning Light Remains ON
    DESCRIPTION The skid control ECU (brake actuator assembly) is connected to the combination meter assembly via CAN communication. If any of the following is detected, the ABS warning light remains ...

    ABS Warning Light does not Come ON
    DESCRIPTION The skid control ECU (brake actuator assembly) is connected to the combination meter assembly via CAN communication. CAUTION / NOTICE / HINT NOTICE: When replacing the skid control E ...

    Other materials:

    Toyota CH-R Service Manual > Smart Key System(for Entry Function): Additional Key cannot be Registered
    DESCRIPTION If additional registration is not possible, a malfunction of the electrical key transmitter sub-assembly, certification ECU (smart key ECU assembly), engine switch, No. 1 indoor electrical key antenna assembly (front floor), steering lock ECU (steering lock actuator or upper brack ...

    Toyota CH-R Service Manual > Hood: On-vehicle Inspection
    ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT HOOD SUB-ASSEMBLY (a) Check that the clearance measurements of areas "A" to "H" are within the standard ranges. Standard Clearance Area Measurement Area Measurement A ...

    Toyota C-HR (AX20) 2023-2026 Owner's Manual

    Toyota CH-R Owners Manual

    Toyota CH-R Service Manual

    © 2017-2026 Copyright www.tochr.net
    0.0091