Toyota CH-R Service Manual: NE Signal (C1224)

Toyota CH-R Service Manual / Brake Control / Dynamic Control Systems / Vehicle Stability Control System / NE Signal (C1224)

DESCRIPTION

The skid control ECU (brake actuator assembly) receives engine speed signals from the ECM via CAN communication.

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

C1224

NE Signal

The vehicle speed is 6 km/h (4 mph) or more, the +BS terminal voltage is between 9.6 and 16.5 V, and the engine speed signal is more than 12800 rpm for 2.5 seconds or more.
  • CAN communication system
  • ECM

PROCEDURE

1.

CHECK CAN COMMUNICATION SYSTEM

(a) Check if CAN communication system DTCs are output.

Click here

Result

Proceed to

DTCs are not output.

A

DTCs are output.

B
B

INSPECT CAN COMMUNICATION SYSTEM

A

2.

CHECK SFI SYSTEM

(a) Check if SFI system DTCs are output.

w/o Canister Pump Module: Click here

w/ Canister Pump Module: Click here

Result

Proceed to

DTCs are not output.

A

DTCs are output.(w/o Canister Pump Module)

B

DTCs are output.(w/ Canister Pump Module)

C
A

REPLACE ECM

B

INSPECT SFI SYSTEM

C

INSPECT SFI SYSTEM

    Stop Light Control Relay Malfunction (C1380)
    DESCRIPTION When the dynamic radar cruise control system*1, pre-collision system*1 or brake hold control system operates, the skid control ECU outputs a stop light drive output (STPO) signal to i ...

    ABS Warning Light Remains ON
    DESCRIPTION The skid control ECU (brake actuator assembly) is connected to the combination meter assembly via CAN communication. If any of the following is detected, the ABS warning light remains ...

    Other materials:

    Toyota CH-R Service Manual > Compressor(for Denso Made): Installation
    INSTALLATION PROCEDURE 1. ADJUST COMPRESSOR OIL (a) When replacing the compressor with pulley assembly with a new one, gradually discharge the refrigerant gas from the service valve. Then drain the following amount of oil from the new compressor with pulley assembly before ...

    Toyota CH-R Service Manual > Black Out Tape(for Front Door): Installation
    INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH side and LH side. The following procedure is for the LH side. PROCEDURE 1. REPAIR INSTRUCTION (a) Clean the vehicle body surface. (1) Using a heat light, heat the vehicle body surface. Heating Temp ...

    Toyota C-HR (AX20) 2023-2026 Owner's Manual

    Toyota CH-R Owners Manual

    Toyota CH-R Service Manual

    © 2017-2026 Copyright www.tochr.net
    0.0106