Toyota CH-R Service Manual: Identification Information

Toyota CH-R Service Manual / Introduction / Identification Information

Vehicle Identification And Serial Numbers

VEHICLE IDENTIFICATION AND SERIAL NUMBERS

VEHICLE IDENTIFICATION NUMBER

(a) The vehicle identification number is stamped on the vehicle body and on the name label as shown in the illustration.

*1

Vehicle Identification Number

*2

Name Label

ENGINE SERIAL NUMBER AND TRANSAXLE SERIAL NUMBER

(a) The engine serial number is stamped on the cylinder block of the engine as shown in the illustration.

*A

3ZR-FAE

-

-

*a

Engine Serial Number

-

-

(b) The transaxle type, transaxle transaxle serial number are stamped on or cast into the transaxle case as shown in the illustration.

*A

K114

-

-

*a

Transaxle Serial Number

-

-

    How To Use This Manual
    General Information GENERAL INFORMATION GENERAL DESCRIPTION (a) Repair operations can be separated mainly into the following 3 processes: (1) Diagnosis. (2) Removing/Installing, Replacing, Disa ...

    Repair Instruction
    ...

    Other materials:

    Toyota CH-R Service Manual > Tire Pressure Warning System: TC and CG Terminal Circuit
    DESCRIPTION DTC output mode is set by connecting terminals 13 (TC) and 4 (CG) of the DLC3. The DTCs are indicated by the blinking of the tire pressure warning light. WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE: When replacing the tire pressure warning ECU and receiver, read the ...

    Toyota CH-R Service Manual > Rear Combination Light Assembly(for Bulb Type): Installation
    INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH side and LH side. The following procedure is for the LH side. PROCEDURE 1. INSTALL REAR COMBINATION LIGHT ASSEMBLY (a) Connect the connector. (b) Engage the guide, pin and clip to temporarily instal ...

    © 2017-2021 Copyright www.tochr.net
    0.0134