DIAGNOSIS SYSTEM
DESCRIPTION
(a) Automatic headlight beam level control system data and Diagnostic Trouble Codes (DTCs) can be read from the Data Link Connector 3 (DLC3) of the vehicle. When the system seems to be malfunctioning, use the Techstream to check for malfunctions and perform repairs.
CHECK DLC3
(a) Check the DLC3.
Click here
INSPECT BATTERY VOLTAGE
(a) Measure the battery voltage.
Standard Voltage:
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery.
DIAGNOSIS SYSTEM
(a) If the automatic headlight beam level control system malfunctions, "Headlight System Malfunction Visit Your Dealer" warning message is displayed on the multi-information display.
HINT:
In this case, the headlight ECU sub-assembly LH stores DTCs.
Problem Symptoms Table
Terminals Of EcuToyota CH-R Service Manual > Power Window Control System: Rear Power Window LH Auto Up / Down Function does not Operate with Rear Power
Window Switch LH
DESCRIPTION
If the manual up and down functions operate normally but the auto up and down
functions do not, the power window control system may be in fail-safe mode.
If power window initialization has not been performed, the auto up and down functions
will not operate.
Click here
WIRING ...
Toyota CH-R Service Manual > Steering Pad: Installation
INSTALLATION
PROCEDURE
1. INSTALL HORN BUTTON ASSEMBLY
(a) Check that the ignition switch off.
(b) Check that the cable is disconnected from the negative (-) battery terminal.
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-)
battery terminal to disable th ...