PROBLEM SYMPTOMS TABLE
NOTICE:
If the headlight ECU sub-assembly LH has been replaced, it is necessary to synchronize the vehicle information and initialize the headlight ECU sub-assembly LH.
Click here
HINT:
Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
Automatic Headlight Beam Level Control System|
Symptom |
Suspected Area |
Link |
|---|---|---|
|
Automatic headlight beam level control system does not operate (Left Headlight) |
Headlight Unit Assembly LH*1 |
|
|
Headlight Unit Assembly LH*2 |
|
|
|
Headlight ECU sub-assembly LH |
|
|
|
Automatic headlight beam level control system does not operate (Right Headlight) |
Headlight Unit Assembly RH*1 |
|
|
Headlight Unit Assembly RH*2 |
|
|
|
Headlight ECU sub-assembly RH |
|
|
|
Initialization cannot be performed |
CAN communication system |
|
|
Headlight ECU sub-assembly LH |
|
Initialization
Diagnosis SystemToyota CH-R Service Manual > Safety Connect System: Airbag Signal Malfunction/Not Input (B15C4)
DESCRIPTION
If the DCM (Telematics Transceiver) detects an error in communication between
the DCM (Telematics Transceiver) and the airbag sensor assembly as a result of the
DCM (Telematics Transceiver) self check, this DTC will be set.
DTC No.
Detection Item
DT ...
Toyota CH-R Service Manual > Immobiliser System(w/o Smart Key System): Dtc Check / Clear
DTC CHECK / CLEAR
CHECK FOR TRANSPONDER KEY ECU ASSEMBLY DTC
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Immobiliser / Trouble Codes.
Body Electrical > Immobiliser > Trouble Codes ...