ON-VEHICLE INSPECTION
CAUTION / NOTICE / HINT
CAUTION:
Be sure to correctly follow the removal and installation procedures for the lower No. 1 instrument panel airbag assembly.
PROCEDURE
1. INSPECT LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (for Vehicle not Involved in Collision)
(a) Perform a diagnostic system check.
Click here
(b) Visually check for defects with the lower No. 1 instrument panel airbag assembly installed to the vehicle.
HINT:
The defects are as follows:
OK:
No defects are found.
If any defects are found, replace the lower No. 1 instrument panel airbag assembly with a new one.
2. INSPECT LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (for Vehicle Involved in Collision and Airbag not Deployed)
(a) Perform a diagnostic system check.
Click here
(b) Visually check for defects with the lower No. 1 instrument panel airbag assembly removed from the vehicle.
HINT:
The defects are as follows:
OK:
No defects are found.
If any defects are found, replace the lower No. 1 instrument panel airbag assembly, No. 1 instrument panel brace sub-assembly, No. 3 instrument panel to cowl brace sub-assembly, lower No. 1 instrument panel airbag door, instrument panel lower center finish panel or fuse box opening cover with a new one.
Toyota CH-R Service Manual > Instrument Panel Safety Pad: Reassembly
REASSEMBLY
PROCEDURE
1. INSTALL NO. 1 INSTRUMENT PANEL CUSHION
(a) Install a new instrument panel cushion as shown in the illustration.
Standard Measurement:
Area
Measurement
A
3.0 mm (0.118 in.)
...
Toyota CH-R Service Manual > Vehicle Stability Control System: Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
If there are no DTCs output and the problem still occurs, check the suspected
areas for each problem symptom in the order given in the following table and proceed
to the relevant troubleshooting page.
NOTICE:
When replacing the skid control ECU (brake actuator assembly) ...