DIAGNOSIS SYSTEM
DESCRIPTION
(a) The DCM (Telematics Transceiver) control the vehicle safety connect system functions. Safety connect system data and Diagnostic Trouble Codes (DTCs) can be read through the vehicle Data Link Connector 3 (DLC3). In some cases, a malfunction may be occurring in the safety connect system. When the system seems to be malfunctioning, use the Techstream to check for malfunctions and perform repairs.
CHECK DLC3
(a) Check the DLC3.
Click here
INSPECT BATTERY VOLTAGE
(a) Measure the battery voltage.
Standard Voltage:
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery.
CHECK INDICATOR
(a) When a malfunction is detected in the safety connect system, the manual (SOS) switch red indicator on the manual (SOS) switch illuminates to inform the driver of the malfunction.
Click here
Terminals Of Ecu
Dtc Check / ClearToyota CH-R Service Manual > Tire Pressure Warning System: Tire Pressure Warning Light Circuit
DESCRIPTION
If the tire pressure warning ECU and receiver detects any problems, the tire
pressure warning light blinks (stays on after blinking for 1 minute) and tire pressure
monitoring is canceled at the same time. At this time, the ECU stores a DTC in memory.
Connecting terminals TC and CG ...
Toyota CH-R Service Manual > Steering Gear: Inspection
INSPECTION
PROCEDURE
1. INSPECT TIE ROD END SUB-ASSEMBLY LH
(a) Secure the tie rod end sub-assembly LH in a vise between aluminum
plates.
NOTICE:
Do not overtighten the vise.
(b) Install the nut to the stud bolt.
(c) Flip the ...