Toyota CH-R Service Manual: Installation

INSTALLATION

CAUTION / NOTICE / HINT

HINT:

  • Use the same procedure for the RH side and LH side.
  • The following procedure is for the LH side.

PROCEDURE

1. INSTALL OUTER MIRROR

(a) Connect the 2 connectors.

(b) w/ Blind Spot Monitor:

(1) Connect the connector.

(c) Engage the claws to install the outer mirror as shown in the illustration.

Install in this Direction

NOTICE:

Do not push the outer mirror with excessive force. Doing so may break the mirror surface.

    Inspection
    INSPECTION PROCEDURE 1. INSPECT OUTER MIRROR LH (a) Check the resistance. (1) Measure the resistance according the value(s) in the table below. Standard Resistance: ...

    Power Mirror Control System
    ...

    Other materials:

    Toyota CH-R Service Manual > Can Communication System: Check Bus 2 Line for Short to +B
    DESCRIPTION There may be a short circuit between one of the CAN bus lines and +B when no resistance exists between terminal 18 (CA4H) of the central gateway ECU (network gateway ECU) and terminal 16 (BAT) of the DLC3, or terminal 17 (CA4L) of the central gateway ECU (network gateway ECU) and ...

    Toyota CH-R Service Manual > Meter / Gauge System: Data List / Active Test
    DATA LIST / ACTIVE TEST DATA LIST NOTICE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not. HINT: Using the Techstream to read the Data List allows the ...

    © 2017-2019 Copyright www.tochr.net
    0.024