DESCRIPTION
This DTC is stored when the skid control ECU (brake actuator assembly) receives an internal malfunction signal from the steering angle sensor.
|
DTC No. |
Detection Item |
DTC Detection Condition |
Trouble Area |
|---|---|---|---|
|
C1433 |
Steering Angle Sensor Internal Circuit |
With the +BS terminal voltage between 9.6 and 16.5 V, a steering angle sensor malfunction signal is received from the steering angle sensor. |
Steering angle sensor |
PROCEDURE
|
1. |
REPLACE STEERING ANGLE SENSOR |
(a) Replace the steering angle sensor.
Click here
HINT:
If troubleshooting has been carried out according to Problem Symptoms Table, refer back to the table and proceed to the next step before replacing parts.
Click here
| NEXT | |
END |
Steering Angle Sensor Power Source Voltage Malfunction (C1432)
Steering Angle Sensor Output Malfunction (C1434)Toyota CH-R Service Manual > Rear Door Courtesy Switch: Inspection
INSPECTION
PROCEDURE
1. INSPECT REAR DOOR COURTESY LIGHT SWITCH ASSEMBLY
(a) Check the resistance.
(1) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection
Condition
Spec ...
Toyota CH-R Owners Manual > If you have a flat tire: Location of the spare tire, jack and tools
Towing eyelet
Wheel nut wrench
Jack
Jack handle
Spare tire
WARNINGâ– Using the tire jack Observe the
following precautions.
Improper use of the tire jack may cause the vehicle to suddenly fall off
the jack, leading to death or serious injury.
Do not use the tire ja ...