DESCRIPTION
This DTC is stored when the blind spot monitor sensor RH (Slave) detects an internal malfunction.
|
DTC No. |
Detection Item |
DTC Detection Condition |
Trouble Area |
|---|---|---|---|
|
C1AB7 |
Blind Spot Monitor Slave Module |
The blind spot monitor sensor RH (slave) detects an internal malfunction |
Blind spot monitor sensor RH (Slave) |
CAUTION / NOTICE / HINT
NOTICE:
When checking for DTCs, make sure that the blind spot monitor system is turned on.
PROCEDURE
|
1. |
CHECK DTC |
(a) Turn the ignition switch off.
(b) Turn the ignition switch to ON.
(c) Recheck for DTCs and check if the same DTC is output again.
Body Electrical > Blind Spot Monitor Slave > Trouble CodesOK:
No DTCs are output.
| OK | |
USE SIMULATION METHOD TO CHECK
|
| NG | |
REPLACE BLIND SPOT MONITOR SENSOR RH (SLAVE) |
Blind Spot Monitor Master Module (C1AB6)
Open in Outer Mirror Indicator(Slave) (C1AB5)Toyota CH-R Service Manual > Vehicle Stability Control System: Open or Short in Brake Pedal Load Sensing Switch (C1429)
DESCRIPTION
The brake pedal load sensing switch turns on when the brake pedal is depressed
with a force exceeding a predetermined level.
The skid control ECU uses this circuit to detect if the brake pedal is depressed
or not.
DTC No.
Detection Item
DTC Detecti ...
Toyota CH-R Service Manual > Power Window Regulator Motor(for Rear Door): Inspection
INSPECTION
CAUTION / NOTICE / HINT
NOTICE:
Do not apply positive (+) battery voltage to any terminals, except terminal
2 (B), to avoid damaging the pulse sensor inside the motor.
Perform initialization of the power window system after removing, inspecting
or replacing the powe ...