DESCRIPTION
This DTC is stored when the blind spot monitor sensor LH (Master) detects an internal malfunction.
|
DTC No. |
Detection Item |
DTC Detection Condition |
Trouble Area |
|---|---|---|---|
|
C1AB6 |
Blind Spot Monitor Master Module |
The blind spot monitor sensor LH (master) detects an internal malfunction |
Blind spot monitor sensor LH (Master) |
CAUTION / NOTICE / HINT
NOTICE:
When checking for DTCs, make sure that the blind spot monitor system is turned on.
PROCEDURE
|
1. |
CHECK DTC |
(a) Turn the ignition switch off.
(b) Turn the ignition switch to ON.
(c) Recheck for DTCs and check if the same DTC is output again.
Body Electrical > Blind Spot Monitor Master > Trouble CodesOK:
No DTCs are output.
| OK | |
USE SIMULATION METHOD TO CHECK
|
| NG | |
REPLACE BLIND SPOT MONITOR SENSOR LH (MASTER) |
Blind Spot Monitor Master Module Beam Axis Inspection Incomplete (C1ABB)
Blind Spot Monitor Slave Module (C1AB7)Toyota CH-R Service Manual > Rear Door Window Frame Moulding: Components
COMPONENTS
ILLUSTRATION
*1
REAR DOOR OUTSIDE MOULDING SUB-ASSEMBLY
*2
REAR DOOR REAR WINDOW FRAME MOULDING
*3
REAR DOOR UPPER WINDOW FRAME MOULDING
*4
REAR DOOR WEATHERSTRIP
*5
...
Toyota CH-R Service Manual > Rear Axle Hub: On-vehicle Inspection
ON-VEHICLE INSPECTION
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE
1. REMOVE REAR WHEEL
Click here
2. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY
Click here
3. REMOVE REAR DI ...