DESCRIPTION
This means that the DCM (Telematics Transceiver) has detected a malfunction in the safety connect system and stored a DTC.
PROCEDURE
|
1. |
CHECK DTC |
(a) Turn the ignition switch off.
(b) Connect the Techstream to the DLC3.
(c) Turn the ignition switch ON and wait for 10 seconds.
(d) Turn the Techstream on.
(e) Perform "Health Check" and check for current DTCs.
Click here
|
Result |
Proceed to |
|---|---|
|
DTCs are not output |
A |
|
DTCs are output |
B |
| B | |
GO TO DIAGNOSTIC TROUBLE CODE CHART |
|
|
2. |
REPLACE DCM (TELEMATICS TRANSCEIVER) |
(a) Replace the DCM (Telematics Transceiver).
Click here
NOTICE:
| NEXT | |
PERFORM DCM ACTIVATION |
Green Indicator Remains Off
Unable To Connect To Call CenterToyota CH-R Service Manual > Windshield Deicer System: System Description
SYSTEM DESCRIPTION
GENERAL
The windshield deicer thin heater wires are attached to the inside of the windshield
glass to help deice the window surface more quickly. The indicator light illuminates
while the system is operating. The system automatically turns off after approximately
15 minute ...
Toyota CH-R Service Manual > Can Communication System: Check Bus 1 Line for Short to GND
DESCRIPTION
There may be a short circuit between one of the CAN bus lines and GND when there
is no resistance between terminal 23 (CA1H) of the central gateway ECU (network
gateway ECU) and terminal 4 (CG) of the DLC3, or terminal 8 (CA1L) of the central
gateway ECU (network gateway ECU) and ...