Toyota CH-R Service Manual: Removal

REMOVAL

CAUTION / NOTICE / HINT

HINT:

  • Use the same procedure for the RH and LH sides.
  • The procedure listed below is for the LH side.

PROCEDURE

1. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP

Click here

2. REMOVE FRONT PILLAR GARNISH ASSEMBLY

Click here

3. REMOVE NO. 1 INSTRUMENT PANEL SPEAKER PANEL SUB-ASSEMBLY

Click here

4. REMOVE FRONT NO. 2 SPEAKER ASSEMBLY

NOTICE:

Do not touch the speaker cone.

(a) Disengage the claws to remove the front No. 2 speaker assembly.

    Components
    COMPONENTS ILLUSTRATION *1 FRONT DOOR OPENING TRIM WEATHERSTRIP *2 FRONT NO. 2 SPEAKER ASSEMBLY *3 FRONT PILLAR GARNISH ASSE ...

    Inspection
    INSPECTION PROCEDURE 1. INSPECT FRONT NO. 2 SPEAKER ASSEMBLY (a) Check the resistance. (1) Measure the resistance according to the value(s) in the table below. Standard Resistance: ...

    Other materials:

    Toyota CH-R Owners Manual > Steps to take in an emergency: If a warning light turns on or a warning buzzer sounds
    Calmly perform the following actions if any of the warning lights comes on or flashes. If a light comes on or flashes, but then goes off, this does not necessarily indicate a malfunction in the system. However, if this continues to occur, have the vehicle inspected by your Toyota dealer. Warn ...

    Toyota CH-R Service Manual > Automatic Headlight Beam Level Control System: Height Control Sensor Data Out of Range When Initializing (B2452)
    DESCRIPTION The headlight ECU sub-assembly LH stores this DTC if the sensor value received from the rear height control sensor sub-assembly LH is out of range when performing initialization of the headlight ECU sub-assembly LH; for example, the vehicle is not level or being jack up. ...

    © 2017-2021 Copyright www.tochr.net
    0.0201