Toyota CH-R Service Manual: Inspection

INSPECTION

PROCEDURE

1. INSPECT FRONT NO. 2 SPEAKER ASSEMBLY

(a) Check the resistance.

(1) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

for RH

Tester Connection

Condition

Specified Condition

4 (TWR+) - 2 (TWR-)

Always

10 kΩ or higher

1 (-) - 2 (TWR-)

Always

Below 1 Ω

3 (+) - 4 (TWR+)

Always

Below 1 Ω

for LH

Tester Connection

Condition

Specified Condition

4 (TWL+) - 2 (TWL-)

Always

10 kΩ or higher

1 (-) - 2 (TWL-)

Always

Below 1 Ω

3 (+) - 4 (TWL+)

Always

Below 1 Ω

If the result is not as specified, replace the front No. 2 speaker assembly.

*A

for RH

*B

for LH

*a

Component without harness connected

(Front No. 2 Speaker Assembly)

    Removal
    REMOVAL CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH and LH sides. The procedure listed below is for the LH side. PROCEDURE 1. DISCONNECT FRONT DOOR OPENING T ...

    Installation
    INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH and LH sides. The procedure listed below is for the LH side. PROCEDURE 1. INSTALL FRONT NO. 2 SPEAKE ...

    Other materials:

    Toyota CH-R Service Manual > Can Communication System: Check Bus 1 Line for Short to +B
    DESCRIPTION There may be a short circuit between one of the CAN bus lines and +B when no resistance exists between terminal 23 (CA1H) of the central gateway ECU (network gateway ECU) and terminal 16 (BAT) of the DLC3, or terminal 8 (CA1L) of the central gateway ECU (network gateway ECU) and t ...

    Toyota CH-R Service Manual > Airbag System: Short in Front Passenger Side Squib Circuit (B1805/52-B1808/52)
    DESCRIPTION The front passenger side squib circuit consists of the airbag sensor assembly and instrument panel passenger without door airbag assembly. The airbag sensor assembly uses this circuit to deploy the airbag when deployment conditions are met. These DTCs are stored when a malfunction ...

    © 2017-2019 Copyright www.tochr.net
    0.0187