INSTALLATION
PROCEDURE
1. INSTALL TRANSMISSION REVOLUTION SENSOR (NT)
(a) Apply Toyota Genuine CVT fluid FE to a new O-ring.
(b) Install the O-ring to the transmission revolution sensor (NT).
(c) Install the transmission revolution sensor (NT) to the continuously variable transaxle assembly with the bolt.
Torque:
5.4 N·m {55 kgf·cm, 48 in·lbf}
(d) Connect the connector.
2. INSTALL TRANSMISSION REVOLUTION SENSOR (NOUT)
(a) Apply Toyota Genuine CVT fluid FE to a new O-ring.
(b) Install the O-ring to the transmission revolution sensor (NOUT).
(c) Install the transmission revolution sensor (NOUT) to the continuously variable transaxle assembly with the bolt.
Torque:
5.4 N·m {55 kgf·cm, 48 in·lbf}
(d) Connect the connector.
3. INSTALL TRANSMISSION REVOLUTION SENSOR (NIN)
(a) Apply Toyota Genuine CVT fluid FE to a new O-ring.
(b) Install the O-ring to the transmission revolution sensor (NIN).
(c) Install the transmission revolution sensor (NIN) to the continuously variable transaxle assembly with the bolt.
Torque:
5.4 N·m {55 kgf·cm, 48 in·lbf}
(d) Connect the connector.
4. INSTALL BATTERY CLAMP SUB-ASSEMBLY
Click here
5. INSTALL ECM
Click here
6. INSTALL AIR CLEANER CASE SUB-ASSEMBLY
Click here
7. INSTALL AIR CLEANER CAP WITH AIR CLEANER HOSE
Click here
8. INSTALL NO. 1 AIR CLEANER INLET
Click here
9. INSTALL RADIATOR COVER
Click here
10. INSTALL BATTERY
Click here
11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Click here
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click here
12. INSTALL NO. 2 CYLINDER HEAD COVER
Click here
13. CHECK DATA LIST
Click here
Toyota CH-R Service Manual > Front Airbag Sensor: On-vehicle Inspection
ON-VEHICLE INSPECTION
CAUTION / NOTICE / HINT
CAUTION:
Be sure to correctly follow the removal and installation procedures for the front
airbag sensors.
PROCEDURE
1. INSPECT FRONT AIRBAG SENSOR (for Vehicle not Involved in Collision)
(a) Perform a diagnostic system check.
Click here
2. I ...
Toyota CH-R Service Manual > Tire Pressure Warning System: Transmitter ID1 Error (C2141/41-C2145/45)
DESCRIPTION
The tire pressure warning valve and transmitters that are installed in the tire
and wheel assemblies measure the tire pressures. The measured values are transmitted
to the tire pressure warning ECU and receiver in the vehicle as radio waves. The
ECU compares the measured tire pres ...