DESCRIPTION
The No. 1 stereo jack adapter assembly sends the sound data signal or image data signal from a USB device to the radio and display receiver assembly via this circuit.
WIRING DIAGRAM
PROCEDURE
|
1. |
CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY) |
(a) Disconnect the radio and display receiver assembly connector.
(b) Disconnect the No. 1 stereo jack adapter assembly connector.
|
(c) Measure the resistance according to the value(s) in the table below. Standard Resistance:
|
|
| OK | |
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE |
| NG | |
REPAIR OR REPLACE HARNESS OR CONNECTOR |
Sound Signal Circuit between Radio Receiver and Stereo Jack Adapter
Mute Signal Circuit between Radio Receiver and Telematics TransceiverToyota CH-R Service Manual > Fog Light Assembly: Disassembly
DISASSEMBLY
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the LH and RH sides.
The procedure described below is for the LH side.
PROCEDURE
1. REMOVE FOG LIGHT BULB
(a) Turn the fog light bulb in the direction indicated by the arrow shown
in the illus ...
Toyota CH-R Service Manual > Rear Disc Brake Pad(for Tmc Made): Components
COMPONENTS
ILLUSTRATION
*1
REAR DISC BRAKE CYLINDER ASSEMBLY
*2
REAR NO. 2 DISC BRAKE ANTI-SQUEAL SHIM
*3
REAR NO. 1 DISC BRAKE ANTI-SQUEAL SHIM
*4
REAR DISC BRAKE ANTI-SQUEAL SHIM KIT
...