Toyota CH-R Service Manual: System Description

SYSTEM DESCRIPTION

IMMOBILISER SYSTEM DESCRIPTION

The immobiliser system is designed to prevent the vehicle from being stolen. This system uses the transponder key ECU assembly that stores the key ID codes of authorized ignition keys. If an attempt is made to start the engine using an unauthorized key, the transponder key ECU assembly sends a signal to the ECM to prohibit fuel delivery and ignition, effectively disabling the engine.

FUNCTION OF MAIN COMPONENTS

Component

Outline

Transponder key ECU assembly

  • When a key is inserted into the ignition key cylinder, the transponder key ECU assembly checks if the key ID code received from the transponder key coil and registered key ID code match.
  • When the engine is started, the transponder key ECU assembly checks if the engine ID codes stored in the ECM and transponder key ECU assembly match.

Transponder key coil

When a key is inserted into the ignition key cylinder, the transponder key amplifier receives the key ID code from the transponder chip in the key grip and outputs it to the transponder key ECU assembly.

ECM

The ECM receives key ID code verification results from the transponder key ECU assembly. The ECM also verifies the ECUs. Then judgment of whether to immobilise the engine is made.

Unlock warning switch assembly

The unlock warning switch assembly detects if the key is in the ignition key cylinder and outputs the result to the transponder key ECU assembly.

SYSTEM FUNCTION

(a) When the transponder key ECU assembly detects that the unlock warning switch assembly is on, the transponder key ECU assembly applies current to the transponder key coil and produces a magnetic field around the antenna coil. A transponder chip in the key grip outputs a key ID code signal using electromotive force generated by the magnetic field. The transponder key coil receives the signal and sends it to the transponder key ECU assembly. The transponder key ECU assembly checks if the key ID code received from the transponder key coil matches the registered key ID code.

When the engine is started, the ECM communicates with the transponder key ECU assembly and checks the key verification result. In addition, the ECM checks if the engine ID codes stored in the transponder key ECU assembly and ECM match. If they do not match, the ECM prohibits engine start.

    How To Proceed With Troubleshooting
    CAUTION / NOTICE / HINT HINT: Use this procedure to troubleshoot the immobiliser system. *: Use the Techstream. PROCEDURE 1. VEHICLE BROUGHT TO WORKSHOP ...

    Problem Symptoms Table
    PROBLEM SYMPTOMS TABLE HINT: Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are lis ...

    Other materials:

    Toyota CH-R Service Manual > Power Mirror Control System: Terminals Of Ecu
    TERMINALS OF ECU CHECK MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) AND INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY (w/ Retract Mirror) (a) Remove the main body ECU (multiplex network body ECU) from the instrument panel junction block assembly. Click here (b) Reconnect the instrument pane ...

    Toyota CH-R Service Manual > Back Door Outside Garnish: Disassembly
    DISASSEMBLY PROCEDURE 1. REMOVE NO. 2 BACK DOOR OUTSIDE GARNISH (a) Remove the 7 No. 1 outside moulding retainers and No. 2 back door outside garnish as shown in the illustration. Remove in this Direction 2. REMOVE BACK DOOR GARNISH SIDE PROTECTOR LH ...

    © 2017-2019 Copyright www.tochr.net
    0.0161