Toyota CH-R Service Manual: Problem Symptoms Table

PROBLEM SYMPTOMS TABLE

HINT:

  • Inspect the fuses and relays related to this system before inspecting the suspected areas below.
  • If the problem only occurs in certain locations or at certain times of day, check for wave interference.
  • If the optional components are installed, check for wave interference from the components.
Immobiliser System

Symptom

Suspected Area

Link

Security indicator light does not blink

Proceed to "Security Indicator Light Does not Blink"

Immobiliser system does not operate properly

Proceed to "Immobiliser System does not Operate Properly"

Engine cannot be started*1

Certification ECU (Smart key ECU assembly)

ECM

-

SFI system

-

Power source mode cannot be changed*1

Engine switch

Certification ECU (Smart key ECU assembly)

-

Steering lock lock/unlock not possible*2

Steering lock ECU (Steering lock actuator or upper bracket assembly)

  • *1: Refer to Problem Symptoms Table for Smart Key System (for Start Function).
  • *2: Refer to Problem Symptoms Table for Steering Lock System.
    How To Proceed With Troubleshooting
    CAUTION / NOTICE / HINT HINT: Use this procedure to troubleshoot the immobiliser system. *: Use the Techstream. PROCEDURE 1. VEHICLE BROUGHT TO WORKSHOP ...

    Registration
    REGISTRATION PROCEDURE 1. CAUTION REGARDING INTERFERENCE WITH ELECTRONIC DEVICES CAUTION: People with implantable cardiac pacemakers, cardiac resynchronization therapy-pacemakers or im ...

    Other materials:

    Toyota CH-R Service Manual > Safety Connect System: Telematics Transceiver Malfunction (B15A8)
    DESCRIPTION This DTC is set when an error in the EEPROM or PLL IC is detected on the DCM (Telematics Transceiver) self-check. The EEPROM (Electrically Erasable Programmable Read-Only Memory) stores the various data to operate the safety connect system. The PLL IC (Phase-Locked Loop Integrated ...

    Toyota CH-R Service Manual > Pre-collision System: Other System Malfunction (C1A63)
    DESCRIPTION The millimeter wave radar sensor receives the throttle signal from the ECM and judges whether the driver is making an acceleration request. When the ECM detects an electronic throttle malfunction, it informs the millimeter wave radar sensor via CAN communication and sets DTC C1A63. ...

    © 2017-2020 Copyright www.tochr.net
    0.0233