DIAGNOSTIC TROUBLE CODE CHART
Smart Key System (for Start Function)|
DTC No. |
Detection Item |
Link |
|---|---|---|
|
B2271 |
Ignition Hold Monitor Malfunction |
|
|
B2274 |
ACC Monitor Malfunction |
|
|
B2277 |
Detecting Vehicle Submersion |
|
|
B2278 |
Engine/Power Switch Malfunction |
|
|
B2282 |
Vehicle Speed Signal Malfunction |
|
|
B2283 |
Vehicle Speed Sensor Malfunction |
|
|
B2284 |
Brake Signal Malfunction |
|
|
B2285 |
Steering Lock Position Signal Circuit Malfunction |
|
|
B2286 |
Runnable Signal Malfunction |
|
|
B228B |
System Voltage or GND Energization Malfunction |
|
|
P0335 |
Crankshaft Position Sensor Circuit Malfunction (NE Signal) |
|
|
U0100 |
Lost Communication with ECM / PCM |
|
|
U0140 |
Lost Communication with Main Body ECU |
|
|
U0142 |
Lost Communication with Main Body ECU |
|
|
U0155 |
Lost Communication with Combination Meter |
|
|
U1117 |
Lost Communication with Accessory Gateway |
|
Data List / Active Test
Lost Communication with ECM / PCM (U0100,U0140,U0142,U0155,U1117)Toyota CH-R Service Manual > Pre-collision System: Front Camera Module Incorrect Axial Gap (C1AA8,C1AA9)
DESCRIPTION
If the millimeter wave radar sensor assembly detects that the forward recognition
camera beam has an axis misalignment, DTC C1AA8 is output.
Also if forward recognition axis adjustment has not been performed or did not
complete normally after the forward recognition camera was repl ...
Toyota CH-R Service Manual > Rocker Panel Moulding: Removal
REMOVAL
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE
1. REMOVE REAR WHEEL HOUSE FRONT PLATE
Click here
2. REMOVE ROCKER PANEL MOULDING
(a) Apply protective tape around the rocker ...