Components
COMPONENTS
ILLUSTRATION
|
*A |
for Type A |
*B |
for Type B |
|
*1 |
DECK BOARD ASSEMBLY |
- |
- |
ILLUSTRATION
|
*1 |
NO. 3 INDOOR ELECTRICAL KEY ANTENNA ASSEMBLY |
- |
- |
Removal
REMOVAL
PROCEDURE
1. REMOVE DECK BOARD ASSEMBLY
Click here
2. REMOVE NO. 3 INDOOR ELECTRICAL KEY ANTENNA ASSEMBLY
(a) Fold the rear seatback assembly RH forward.
(b) Disconnect the connector.
|
Remove in this Direction |
(c) Using a clip remover, disengage the clamp to remove the No. 3 indoor electrical key antenna assembly as shown in the illustration.
NOTICE:
Be careful when removing the No. 3 indoor electrical key antenna assembly. If the No. 3 indoor electrical key antenna assembly is dropped, replace it with a new one.
Installation
INSTALLATION
PROCEDURE
1. INSTALL NO. 3 INDOOR ELECTRICAL KEY ANTENNA ASSEMBLY
(a) Engage the clamp to install the No. 3 indoor electrical key antenna assembly as shown in the illustration.
|
Install in this Direction |
NOTICE:
Be careful when installing the No. 3 indoor electrical key antenna assembly. If the No. 3 indoor electrical key antenna assembly is dropped, replace it with a new one.
(b) Connect the connector.
(c) Pull back the rear seatback assembly RH.
2. INSTALL DECK BOARD ASSEMBLY
Click here
Electrical Key Oscillator(for Front Floor)
Electrical Key Oscillator(for Outside Luggage Compartment)Toyota CH-R Service Manual > Brake Actuator: Precaution
PRECAUTION
IGNITION SWITCH EXPRESSIONS
(a) The type of ignition switch used on this model differs depending on the specifications
of the vehicle. The expressions listed in the table below are used in this section.
Expression
Ignition Switch (Position)
Engine Swi ...
Toyota CH-R Service Manual > Rear Door Outside Moulding: Reassembly
REASSEMBLY
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE
1. INSTALL NO. 2 OUTSIDE MOULDING RETAINER
(a) When using a new rear door rear outside moulding:
(1) Clean the surface of a new r ...