Components
COMPONENTS
ILLUSTRATION
|
*1 |
NO. 1 INDOOR ELECTRICAL KEY ANTENNA ASSEMBLY |
- |
- |
Installation
INSTALLATION
PROCEDURE
1. INSTALL NO. 1 INDOOR ELECTRICAL KEY ANTENNA ASSEMBLY
(a) Engage the clamp to install the No. 1 indoor electrical key antenna assembly as shown in the illustration.
|
Install in this Direction |
NOTICE:
Be careful when installing the No. 1 indoor electrical key antenna assembly. If the No. 1 indoor electrical key antenna assembly is dropped, replace it with a new one.
(b) Connect the connector.
2. INSTALL REAR CONSOLE BOX ASSEMBLY
Click here
Removal
REMOVAL
PROCEDURE
1. REMOVE REAR CONSOLE BOX ASSEMBLY
Click here
2. REMOVE NO. 1 INDOOR ELECTRICAL KEY ANTENNA ASSEMBLY
(a) Disconnect the connector.
|
Remove in this Direction |
(b) Using a clip remover, disengage the clamp to remove the No. 1 indoor electrical key antenna assembly as shown in the illustration.
NOTICE:
Be careful when removing the No. 1 indoor electrical key antenna assembly. If the No. 1 indoor electrical key antenna assembly is dropped, replace it with a new one.
Certification Ecu
Electrical Key Oscillator(for Luggage Compartment)Toyota CH-R Service Manual > Front Door Outside Moulding: Components
COMPONENTS
ILLUSTRATION
*1
FRONT DOOR OUTSIDE MOULDING
*2
HOLE COVER
*3
GASKET
-
-
ILLUSTRATION
*1
FRONT DOOR UPPER OUTSIDE MOULDING PAD
*2
OUTSI ...
Toyota CH-R Service Manual > Immobiliser System(w/o Smart Key System): Engine does not Start but Initial Combustion Occurs
DESCRIPTION
If the key ID codes of the key and transponder key ECU assembly match, the immobiliser
system is unset and the engine start permission signal is sent to the ECM. When
the ID codes of the transponder key ECU assembly and ECM match, the engine starts.
WIRING DIAGRAM
CAUTION / NOTI ...