Components
COMPONENTS
ILLUSTRATION
|
*1 |
ELECTRICAL KEY ANTENNA |
- |
- |
|
N*m (kgf*cm, ft.*lbf): Specified torque |
- |
- |
Installation
INSTALLATION
PROCEDURE
1. INSTALL ELECTRICAL KEY ANTENNA
(a) Engage the guide to install the electrical key antenna as shown in the illustration.
|
Install in this Direction |
NOTICE:
Be careful when installing the electrical key antenna. If the electrical key antenna is dropped, replace it with a new one.
(b) Install the nut.
Torque:
5.5 N·m {56 kgf·cm, 49 in·lbf}
(c) Connect the connector.
2. INSTALL REAR BUMPER ASSEMBLY
Click here
Removal
REMOVAL
PROCEDURE
1. REMOVE REAR BUMPER ASSEMBLY
Click here
2. REMOVE ELECTRICAL KEY ANTENNA
|
Remove in this Direction |
(a) Disconnect the connector.
(b) Remove the nut.
(c) Disengage the guide to remove the electrical key antenna as shown in the illustration.
NOTICE:
Be careful when removing the electrical key antenna. If the electrical key antenna is dropped, replace it with a new one.
Electrical Key Oscillator(for Luggage Compartment)
Electrical Key Oscillator(for Rear Floor)Toyota CH-R Service Manual > Air Conditioning System(for Automatic Air Conditioning System With Side-mounted
Air Conditioner Pressure Sensor): Pressure Sensor Circuit (B1423)
DESCRIPTION
This DTC is stored if refrigerant pressure on the high pressure side is extremely
low (195 kPa (2.0 kgf/cm2, 28 psi) or less) or extremely high (2812 kPa (28.7 kgf/cm2,
408 psi) or more). The air conditioner pressure (2 words) sensor, which is installed
to the high pressure side p ...
Toyota CH-R Service Manual > Front Passenger Airbag Assembly: Components
COMPONENTS
ILLUSTRATION
*1
INSTRUMENT PANEL PASSENGER AIRBAG ASSEMBLY
*2
NO. 2 INSTRUMENT PANEL WIRE
...