Toyota CH-R Service Manual: On-vehicle Inspection

ON-VEHICLE INSPECTION

CAUTION / NOTICE / HINT

CAUTION:

Be sure to correctly follow the removal and installation procedures for the rear seat airbags.

PROCEDURE

1. INSPECT REAR SEAT AIRBAG (for Vehicle not Involved in Collision)

(a) Perform a diagnostic system check.

Click here

(b) Visually check for defects with the rear seat airbags installed to the vehicle.

HINT:

The defects are as follows:

  • Cuts on the rear seat side garnish around the rear seat airbags
  • Small cracks on the rear seat side garnish around the rear seat airbags
  • Significant discoloration on the rear seat side garnish around the rear seat airbags

OK:

No defects are found.

If any defects are found, replace the rear seat side garnish with a new one.

2. INSPECT REAR SEAT AIRBAG (for Vehicle Involved in Collision and Airbag not Deployed)

(a) Perform a diagnostic system check.

Click here

(b) Visually check for defects with the rear seat airbags removed from the vehicle.

HINT:

The defects are as follows:

  • Cuts
  • Small cracks
  • Significant discoloration
  • Cracks or other damage to the connector
  • Deformation or cracks on the rear seat side garnish

OK:

No defects are found.

If any defects are found, replace the rear seat airbag, rear seat side garnish with a new one.

    Components
    COMPONENTS ILLUSTRATION *1 REAR SEAT AIRBAG - - ...

    Removal
    REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during th ...

    Other materials:

    Toyota CH-R Service Manual > Vehicle Stability Control System: Low Power Supply Voltage Malfunction (C1241)
    DESCRIPTION If a malfunction is detected in the power supply circuit, the skid control ECU (brake actuator assembly) stores this DTC and the fail-safe function prohibits ABS operation. This DTC is stored when the +BS terminal voltage meets one of the DTC detection conditions due to a malfunct ...

    Toyota CH-R Service Manual > Front Door Window Frame Moulding: Installation
    INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH side and LH side. The following procedure is for the LH side. PROCEDURE 1. INSTALL FRONT DOOR FRONT WINDOW FRAME MOULDING (a) Using an air riveter or hand riveter with a nose piece, install the front ...

    Toyota C-HR (AX20) 2023-2026 Owner's Manual

    Toyota CH-R Owners Manual

    Toyota CH-R Service Manual

    © 2017-2026 Copyright www.tochr.net
    0.0078