REMOVAL
PROCEDURE
1. DISCONNECT REAR CENTER SEAT OUTER BELT ASSEMBLY
Click here
2. REMOVE BENCH TYPE REAR SEAT CUSHION ASSEMBLY
Click here
3. REMOVE REAR SEAT CUSHION LOCK HOOK
Click here
4. REMOVE REAR SEAT INNER WITH CENTER BELT ASSEMBLY LH
(a) w/o Seat Belt Warning System:
|
(1) Loosen the bolt and remove the rear seat inner with center belt assembly LH. HINT: The bolt cannot be removed from the rear seat inner with center belt assembly LH. |
|
(b) w/ Seat Belt Warning System:
|
(1) Disconnect the 2 connectors. |
|
(2) Disengage the clamp.
(3) Loosen the bolt and remove the rear seat inner with center belt assembly LH.
HINT:
The bolt cannot be removed from the rear seat inner with center belt assembly LH.
Inspection
InstallationToyota CH-R Service Manual > Vehicle Stability Control System: Yaw Rate Sensor Malfunction (C1436)
DESCRIPTION
This DTC is stored when the skid control ECU (brake actuator assembly) detects
improper installation of the yaw rate and acceleration sensor (airbag sensor assembly)
or an abnormality in the difference between the yaw rate sensor value and the control
value estimated based on the ...
Toyota CH-R Service Manual > Rear Wiper Motor: Installation
INSTALLATION
PROCEDURE
1. INSTALL REAR WIPER MOTOR ASSEMBLY
(a) Install the rear wiper motor assembly with the 3 bolts.
Torque:
5.5 N·m {56 kgf·cm, 49 in·lbf}
(b) Connect the connector.
2. INSTALL REAR WIPER MOTOR GROMMET
(a) Apply MP grease to the entire surface of the rear w ...