INSPECTION
PROCEDURE
1. INSPECT REAR SEAT INNER WITH CENTER BELT ASSEMBLY LH (w/ Seat Belt Warning System)
(a) for LH:
|
(1) Check the resistance. Measure the resistance according to the value(s) in the table below. Standard Resistance:
If the result is not as specified, replace the rear seat inner with center belt assembly LH. |
|
(b) for CENTER:
|
(1) Check the resistance. Measure the resistance according to the value(s) in the table below. Standard Resistance:
If the result is not as specified, replace the rear seat inner with center belt assembly LH. |
|
Components
RemovalToyota CH-R Service Manual > Vacuum Warning Switch: On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT BRAKE FLUID LEVEL IN RESERVOIR
Click here
2. INSPECT BRAKE BOOSTER ASSEMBLY
Click here
3. REMOVE OUTER COWL TOP PANEL SUB-ASSEMBLY
Click here
4. INSPECT VACUUM WARNING SWITCH ASSEMBLY
(a) Start the engine and stop it after 1 or 2 minute ...
Toyota CH-R Service Manual > Continuously Variable Transaxle System: Terminals Of Ecm
TERMINALS OF ECM
ECM
HINT:
The standard voltage and resistance of each ECM terminal is shown in the table
below.
In the table, first follow the information under "Condition". Look under "Terminal
No. (Symbol)" for the terminals to be inspected. The standard voltage or r ...