INSPECTION
PROCEDURE
1. INSPECT OCCUPANT DETECTION SENSOR (SEPARATE TYPE FRONT SEAT CUSHION PAD)
(a) Check the resistance.
|
(1) Measure the resistance according to the value(s) in the table below. Standard Resistance:
If the result is not as specified, replace the occupant detection sensor (separate type front seat cushion pad). |
|
Removal
InstallationToyota CH-R Service Manual > Rear Seat Outer Belt Assembly: Installation
INSTALLATION
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH side and LH side.
The procedure listed below is for the LH side.
PROCEDURE
1. INSPECT REAR SEAT 3 POINT TYPE OUTER BELT ASSEMBLY
Click here
2. INSTALL REAR SEAT 3 POINT TYPE OUTER BELT ASSEMBLY LH ...
Toyota CH-R Service Manual > Rear Combination Light Assembly(for Bulb Type): Disassembly
DISASSEMBLY
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE
1. REMOVE REAR COMBINATION LIGHT LED
(a) Disconnect the connector.
Remove in this Direction
(b) ...