Toyota CH-R Service Manual: Installation

INSTALLATION

CAUTION / NOTICE / HINT

CAUTION:

Wear protective gloves. Sharp areas on the parts may injure your hands.

PROCEDURE

1. INSTALL OCCUPANT DETECTION SENSOR (SEPARATE TYPE FRONT SEAT CUSHION PAD)

NOTICE:

When installing a separate type front seat cushion cover, refer to Precaution in order to prevent wrinkles from forming.

Click here

(a) Engage the claws to install the occupant detection sensor (separate type front seat cushion pad) to the separate type front seat cushion cover.

2. INSTALL SEPARATE TYPE FRONT SEAT CUSHION COVER WITH PAD

HINT:

Use the same procedure as for the driver side.

Click here

3. INSTALL SEPARATE TYPE FRONT SEATBACK ASSEMBLY

HINT:

Use the same procedure as for the driver side.

Click here

4. INSTALL FRONT SEAT INNER CUSHION SHIELD

Click here

5. INSTALL FRONT SEAT CUSHION SHIELD

Click here

6. INSTALL RECLINING ADJUSTER RELEASE HANDLE

HINT:

Use the same procedure as for the driver side.

Click here

7. INSTALL RECLINING HINGE OUTER COVER

HINT:

Use the same procedure as for the driver side.

Click here

8. CONNECT SEPARATE TYPE FRONT SEATBACK COVER

HINT:

Use the same procedure as for the driver side.

Click here

9. INSTALL FRONT SEAT INNER BELT ASSEMBLY

Click here

10. INSTALL FRONT SEAT ASSEMBLY

HINT:

Use the same procedure as for the driver side.

Click here

    Inspection
    INSPECTION PROCEDURE 1. INSPECT OCCUPANT DETECTION SENSOR (SEPARATE TYPE FRONT SEAT CUSHION PAD) (a) Check the resistance. (1) Measure the resistance according to the value(s) in the ta ...

    Rear Center Seat Outer Belt Assembly
    ...

    Other materials:

    Toyota CH-R Service Manual > Tire / Wheel: Tire And Wheel
    Components COMPONENTS ILLUSTRATION *A for Steel Wheel - - *1 WHEEL ASSEMBLY *2 WHEEL CAP *3 AXLE HUB NUT - - Tightening tor ...

    Toyota CH-R Service Manual > Height Control Sensor: Inspection
    INSPECTION PROCEDURE 1. INSPECT REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH (a) Preparation for check (1) Confirm the standard, high and low positions of the link that will be used in the following inspection. The standard position is 58° from the maximum link angle (high) and 51° ...

    © 2017-2019 Copyright www.tochr.net
    0.0242