Toyota CH-R Service Manual: Inspection

INSPECTION

PROCEDURE

1. INSPECT FRONT SEAT OUTER BELT ASSEMBLY

*a

Retractor

*b

Unlock

*c

Lock

*d

45°

(a) Before installing the front seat outer belt assembly, check the ELR.

NOTICE:

Do not disassemble the retractor.

(1) When the inclination of the retractor is 15° or less, check that the belt can be pulled from the retractor. When the inclination of the retractor is over 45°, check that the belt locks.

If the result is not as specified, replace the front seat outer belt assembly.

    Removal
    REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during ...

    Installation
    INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH side and LH side. The procedure listed below is for the LH side. PROCEDURE 1. INSTALL FRONT SHOULDER ...

    Other materials:

    Toyota CH-R Service Manual > Hood: Disassembly
    DISASSEMBLY PROCEDURE 1. REMOVE HOOD SIDE PANEL LH (a) Using a clip remover, disengage the clips to remove the hood side panel LH. 2. REMOVE HOOD SIDE PANEL RH HINT: Use the same procedure as for the LH side. 3. REMOVE HOOD INSULA ...

    Toyota CH-R Service Manual > Rear Stabilizer Bar: Inspection
    INSPECTION PROCEDURE 1. INSPECT REAR STABILIZER LINK ASSEMBLY (a) Inspect the turning torque of the ball joint. (1) Secure the rear stabilizer link assembly in a vise using aluminum plates. NOTICE: Do not overtighten the vise. (2) Install the nut to the rear stabilizer link assembly stud. ...

    Toyota C-HR (AX20) 2023-2026 Owner's Manual

    Toyota CH-R Owners Manual

    Toyota CH-R Service Manual

    © 2017-2026 Copyright www.tochr.net
    0.0101