Toyota CH-R Service Manual: On-vehicle Inspection
ON-VEHICLE INSPECTION
CAUTION / NOTICE / HINT
CAUTION:
Be sure to correctly follow the removal and installation procedures for the front seat outer belt assembly.
PROCEDURE
1. INSPECT FRONT SEAT OUTER BELT ASSEMBLY (for Vehicle not Involved in Collision)
(a) Perform a diagnostic system check.
Click here .gif)
(b) Visually check for defects with the front seat outer belt assembly installed on the vehicle.
(1) The defects to be checked are as follows:
- Cuts on the front seat outer belt assembly
- Small cracks on the front seat outer belt assembly
- Significant discoloration on the front seat outer belt assembly
OK:
No defects are found.
HINT:
If any defects are found, replace the front seat outer belt assembly with a new one.
2. INSPECT FRONT SEAT OUTER BELT ASSEMBLY (for Vehicle Involved in Collision)
(a) Perform a diagnostic system check.
Click here
(b) Visually check for defects with the front seat outer belt assembly removed from the vehicle.
(1) The defects to be checked are as follows:
- Cuts on the front seat outer belt assembly
- Small cracks on the front seat outer belt assembly
- Significant discoloration on the front seat outer belt assembly
- Cracks or other damage to the connector
OK:
No defects are found.
HINT:
If any defects are found, replace the front seat outer belt assembly with a new one.
Components
COMPONENTS
ILLUSTRATION
*A
w/o Rear Seat Side Airbag
*B
w/ Rear Seat Side Airbag
*1
FRONT DOOR OPENING TRIM WEATHERSTRIP
...
Removal
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration)
that must be performed after parts are removed and installed, or replaced during ...
Other materials:
Toyota CH-R Service Manual > Air Conditioning System(for Automatic Air Conditioning System With Top-mounted
Air Conditioner Pressure Sensor): System Diagram
SYSTEM DIAGRAM
Communication Table
Sender
Receiver
Signal
Communication Line
Air conditioning amplifier assembly
ECM
Magnet Clutch request signal
CAN
A/C idle up request si ...
Toyota CH-R Service Manual > Blind Spot Monitor System: Operation Check
OPERATION CHECK
HINT:
The blind spot monitor beam axis confirmation is performed to confirm whether
the sensor's beam axis is correct, and perform adjustment of the beam axis by using
reflector.
BLIND SPOT MONITOR BEAM AXIS CONFIRMATION
(a) When performing the blind spot monitor beam axi ...
Toyota C-HR (AX20) 2023-2025 Owner's Manual
Toyota CH-R Owners Manual
- For safety and security
- Instrument cluster
- Operation of each component
- Driving
- Interior features
- Maintenance and care
- When trouble arises
- Vehicle specifications
- For owners
Toyota CH-R Service Manual
- Introduction
- Maintenance
- Audio / Video
- Cellular Communication
- Navigation / Multi Info Display
- Park Assist / Monitoring
- Brake (front)
- Brake (rear)
- Brake Control / Dynamic Control Systems
- Brake System (other)
- Parking Brake
- Axle And Differential
- Drive Shaft / Propeller Shaft
- K114 Cvt
- 3zr-fae Battery / Charging
- Networking
- Power Distribution
- Power Assist Systems
- Steering Column
- Steering Gear / Linkage
- Alignment / Handling Diagnosis
- Front Suspension
- Rear Suspension
- Tire / Wheel
- Tire Pressure Monitoring
- Door / Hatch
- Exterior Panels / Trim
- Horn
- Lighting (ext)
- Mirror (ext)
- Window / Glass
- Wiper / Washer
- Door Lock
- Heating / Air Conditioning
- Interior Panels / Trim
- Lighting (int)
- Meter / Gauge / Display
- Mirror (int)
- Power Outlets (int)
- Pre-collision
- Seat
- Seat Belt
- Supplemental Restraint Systems
- Theft Deterrent / Keyless Entry
0.0102