Toyota CH-R Service Manual: Inspection

INSPECTION

PROCEDURE

1. INSPECT LUMBAR SUPPORT ADJUSTER ASSEMBLY

(a) Check the operation of the lumbar support adjuster assembly.

(1) Apply battery voltage to the lumbar motor connector, and check that the lumbar support adjuster assembly operates smoothly as follows.

OK:

Battery Connection

Operational Direction

Battery positive (+) → Terminal 1

Battery negative (-) → Terminal 2

Seatback moves forward

Battery positive (+) → Terminal 2

Battery negative (-) → Terminal 1

Seatback moves backward

If the result is not as specified, replace the lumbar support adjuster assembly.

*a

Component without harness connected

(Lumbar Support Adjuster Assembly)

    Removal
    REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during th ...

    Installation
    INSTALLATION CAUTION / NOTICE / HINT CAUTION: Be sure to read Precaution thoroughly before servicing. Click here Wear protective gloves. Sharp areas on the parts may inj ...

    Other materials:

    Toyota CH-R Service Manual > Power Steering System: Torque Sensor1 (C1511-C1514,C1517)
    DESCRIPTION The torque sensor converts the rotational torque received from the steering wheel into electric signals and sends them to the power steering ECU assembly. DTC No. Detection Item DTC Detection Condition Trouble Area Warning Indica ...

    Toyota CH-R Service Manual > Rear Brake(for Tmmt Made): Inspection
    INSPECTION PROCEDURE 1. INSPECT PAD LINING THICKNESS (a) Using a ruler, measure the rear disc brake pad lining thickness. Standard Thickness: 9.5 mm (0.374 in.) Minimum Thickness: 1.0 mm (0.0394 in.) If a rear disc brake pad lining thickness is less than the minimum th ...

    Toyota C-HR (AX20) 2023-2026 Owner's Manual

    Toyota CH-R Owners Manual

    Toyota CH-R Service Manual

    © 2017-2026 Copyright www.tochr.net
    0.0082