Toyota CH-R Service Manual: Removal

REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the front seat cushion heater assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced

Replacement Part or Procedure

Necessary Procedures

Effects/Inoperative when not performed

Link

Disconnect cable from negative battery terminal

Initialize back door lock

Power door lock control system

Memorize steering angle neutral point

Lane departure alert system (w/ Steering Control)

Pre-collision system

CAUTION:

  • Be sure to read Precaution thoroughly before servicing.

    Click here

  • Wear protective gloves. Sharp areas on the parts may injure your hands.

HINT:

  • Use the same procedure for RHD and LHD vehicles.
  • The procedure listed below is for LHD vehicles.
  • Use the same procedure for the driver side and front passenger side.
  • The procedure listed below is for the driver side.

PROCEDURE

1. REMOVE SEPARATE TYPE FRONT SEATBACK ASSEMBLY

Click here

2. REMOVE SEPARATE TYPE FRONT SEAT CUSHION COVER WITH PAD

Click here

3. REMOVE SEPARATE TYPE FRONT SEAT CUSHION COVER

Click here

4. REMOVE FRONT SEAT CUSHION HEATER ASSEMBLY

(a) Remove the 14 tag pins and front seat cushion heater assembly from the separate type front seat cushion cover.

    Inspection
    INSPECTION PROCEDURE 1. INSPECT FRONT SEAT CUSHION HEATER ASSEMBLY LH (a) for TMC Made: (1) Check the resistance. Measure the resistance according to the value(s) in the ...

    Installation
    INSTALLATION CAUTION / NOTICE / HINT CAUTION: Be sure to read Precaution thoroughly before servicing. Click here Wear protective gloves. Sharp areas on the parts may inj ...

    Other materials:

    Toyota CH-R Service Manual > Continuously Variable Transaxle System: Torque Converter Clutch Solenoid Circuit Low (P2769,P2770)
    DESCRIPTION Based on the signal received by the shift solenoid valve SL, the ECM uses the shift solenoid valve SLU to control the lock-up clutch pressure. If there is an open or short in the shift solenoid valve SL circuit, the ECM stops sending current to the defective shift solenoid valve. ...

    Toyota CH-R Service Manual > Vehicle Stability Control System: Yaw Rate Sensor Output Value (C1448)
    DESCRIPTION The yaw rate and acceleration sensor is built into the airbag sensor assembly. The skid control ECU receives signals from the yaw rate and acceleration sensor (airbag sensor assembly) via CAN communication. The airbag sensor assembly has a built-in yaw rate and acceleration sensor a ...

    Toyota C-HR (AX20) 2023-2026 Owner's Manual

    Toyota CH-R Owners Manual

    Toyota CH-R Service Manual

    © 2017-2026 Copyright www.tochr.net
    0.008