INITIALIZATION
RESET BACK-UP BATTERY CONDITION
HINT:
If the back-up battery has been replaced, it is necessary to perform the Reset Backup Battery Condition procedure.
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Telematics / Utility / Backup Battery Replacement Reset
Body Electrical > Telematics > Utility|
Tester Display |
|---|
|
Backup Battery Replacement Reset |
(e) According to the display on the Techstream, perform Backup Battery Replacement Reset to reset the mobilephone battery replacement flag.
Acn Call End
Problem Symptoms TableToyota CH-R Service Manual > Vehicle Stability Control System: Open in Front Speed Sensor RH (C1330-C1467)
DESCRIPTION
Each speed sensor detects wheel speed and sends signals to the skid control ECU
(brake actuator assembly). These signals are used by the ABS.
HINT:
The output voltage values shown below are for when the vehicle wire harnesses
are connected to the skid control ECU (brake actuator a ...
Toyota CH-R Service Manual > Cellular Communication: Back-up Battery
Components
COMPONENTS
ILLUSTRATION
*1
MOBILEPHONE BATTERY
*2
TRANSCEIVER COVER
Removal
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration)
that must be performed after ...