DISASSEMBLY
PROCEDURE
1. REMOVE BRAKE MASTER CYLINDER RESERVOIR ASSEMBLY
(a) Mount the brake master cylinder sub-assembly in a vise.
NOTICE:
Place aluminum plates on the vise to prevent damage to the brake master cylinder sub-assembly.
|
(b) Using an T20 "TORX" socket wrench, remove the "TORX" screw and brake master cylinder reservoir assembly from the brake master cylinder body. NOTICE: Do not drop the brake master cylinder reservoir assembly. |
|
(c) Remove the brake master cylinder body from the vise.
(d) Disengage the claw to remove the wire harness clamp.
2. REMOVE MASTER CYLINDER RESERVOIR GROMMET
(a) Remove the 2 master cylinder reservoir grommets from the brake master cylinder reservoir assembly.
3. REMOVE BRAKE MASTER CYLINDER RESERVOIR FILLER CAP ASSEMBLY
(a) Remove the brake master cylinder reservoir filler cap assembly from the brake master cylinder reservoir assembly.
4. REMOVE BRAKE MASTER CYLINDER RESERVOIR STRAINER
(a) Remove the brake master cylinder reservoir strainer from the brake master cylinder reservoir assembly.
Removal
ReassemblyToyota CH-R Service Manual > Power Window Regulator Motor(for Rear Door): Installation
INSTALLATION
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE
1. INSTALL POWER WINDOW REGULATOR MOTOR ASSEMBLY
(a) Apply MP grease to the sliding and rotating areas of the power window regul ...
Toyota CH-R Service Manual > Lighting (int): Map Light Bulb
Replacement
REPLACEMENT
PROCEDURE
1. REMOVE NO. 1 MAP LIGHT LENS
Click here
2. REMOVE MAP LIGHT BULB
(a) Remove the 2 map light bulbs as shown in the illustration.
Remove in this Direction
3. INSTALL MAP LIGHT BULB
(a) Install the 2 map light bulbs as show ...