ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT RAIN SENSOR
|
(a) Disconnect the R1 rain sensor connector. |
|
(b) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
|
Tester Connection |
Condition |
Specified Condition |
|---|---|---|
|
R1-4 (SIG) - R1-2 (ES) |
Ignition switch ON |
11 to 14 V |
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
|
Tester Connection |
Condition |
Specified Condition |
|---|---|---|
|
R1-2 (ES) - Body ground |
Always |
Below 1 Ω |
If the result is not as specified, repair or replace the harness or connector.
|
(d) Reconnect the R1 rain sensor connector. |
|
(e) Connect an oscilloscope to the rain sensor connector.
(f) Check for pulses.
OK:
|
Tester Connection |
Condition |
Specified Condition |
|---|---|---|
|
3 (MPX) - 2 (ES) |
Ignition switch ON |
Pulse generation |
If the result is not as specified, replace the rain sensor.
Components
RemovalToyota CH-R Service Manual > Smart Key System(for Start Function): Operation Check
OPERATION CHECK
NOTICE:
Make sure that the smart key system (for Start Function) has not been canceled
before performing this inspection.
Click here
OPERATION DESCRIPTION
(a) Push-button start function:
(1) When the electrical key transmitter sub-assembly is in a vehicle interior
detecti ...
Toyota CH-R Service Manual > Outer Rear View Mirror: Removal
REMOVAL
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE
1. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG
Click here
2. REMOVE MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT ARMRES ...