REMOVAL
PROCEDURE
1. REMOVE RAIN SENSOR COVER
(a) Release the stopper by pulling it out as shown in the illustration.
|
*a |
Stopper |
|
Release |
|
Remove in this Direction |
(b) Disconnect the rain sensor with rain sensor cover from the windshield glass as shown in the illustration.
|
(c) Disengage the claws and guide to remove the rain sensor cover. |
|
2. REMOVE RAIN SENSOR
|
(a) Disconnect the connector to remove the rain sensor. |
|
On-vehicle Inspection
InstallationToyota CH-R Service Manual > Automatic High Beam System: Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART
Automatic High Beam System
DTC No.
Detection Item
Link
B124B
Automatic High Beam System
B124C
Automatic High Beam Camera
U ...
Toyota CH-R Service Manual > Wheel Opening Moulding(for Rear): Reassembly
REASSEMBLY
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE
1. INSTALL NO. 1 BODY OUTSIDE MOULDING PAD
HINT:
When installing the No. 1 body outside moulding pad, heat the quarter outside
...