Components
COMPONENTS
ILLUSTRATION
*1 |
FRONT SIDE MARKER LIGHT BULB |
*2 |
FRONT SIDE MARKER LIGHT SOCKET |
Removal
REMOVAL
PROCEDURE
1. REMOVE FRONT SIDE MARKER LIGHT BULB
(a) Disconnect the connector.
(b) Turn the front side marker light socket with the front side marker light bulb in the direction indicated by the arrow shown in the illustration, and remove them as a unit.
![]() |
Remove in this Direction |
(c) Remove the front side marker light bulb from the front side marker light socket.
![]() |
Remove in this Direction |
Installation
INSTALLATION
PROCEDURE
1. INSTALL FRONT SIDE MARKER LIGHT BULB
(a) Install the front side marker light bulb to the front side marker light socket.
![]() |
Install in this Direction |
(b) Turn the front side marker light socket with the front side marker light bulb as shown in the illustration to install them as a unit.
![]() |
Install in this Direction |
(c) Connect the connector.
Toyota CH-R Service Manual > Vehicle Stability Control System: Open in Stop Light Switch Circuit (C1249)
DESCRIPTION
The skid control ECU (brake actuator assembly) receives stop light switch signals
and uses them to determine whether or not the brakes are applied. DTCs may be stored
if either of the following occurs:
Stop light switch stuck on malfunction.
The accelerator and brake ped ...
Toyota CH-R Service Manual > Automatic Headlight Beam Level Control System: Height Control Sensor Data Out of Range When Initializing (B2452)
DESCRIPTION
The headlight ECU sub-assembly LH stores this DTC if the sensor value received
from the rear height control sensor sub-assembly LH is out of range when performing
initialization of the headlight ECU sub-assembly LH; for example, the vehicle is
not level or being jack up.
...